This record describes XBT data collected on RV Investigator voyage IN20119, which departed Hobart on the 11 April 2019 and returned to Hobart on the 23 April 2019. A total of 3 XBT casts were conducted over the duration of this voyage. Data are stored in netCDF files at CSIRO. Additional information regarding this dataset is contained in the GSM data acquisition and processing report. Additional data products may be available on request.

This record describes multibeam echosounder data collected on RV Investigator voyage IN2019_V07, 'RAN Hydrographic and Maritime Heritage Surveys' which departed Hobart on the 11 April 2019 and returned to Hobart on the 23 April 2019. The Kongsberg EM710 MKII multibeam echosounder was used to acquire seafloor bathymetry and backscatter information [and watercolumn backscatter] along the Tasmanian East coast and in the central to eastern region of Bass Strait. The EM710 MKII provides a 0.5° by 1° transmit and receive angular resolution respectively. The echosounder's nominal frequency range is from 40 to 100 kHz. Data are stored in *.all raw format for bathymetry and backscatter and *.wcd format for watercolumn backscatter at CSIRO. There are 337 files totalling 67 GB of raw data in this dataset. Sound velocity profiles were applied to this data during data acquisition. Bathymetry data contained in *.all format are corrected for motion and position. Tide corrections were applied to some of the processed data (i.e. AHO mapping area - files 0037 to 0112, and to other mapping sites - files 0188 to 0256). GPS tides (and reduction to AHD using AusGeoid 09) was applied to the BMR mapping areas (files 0257 to 0281, 0290 to 0293 & 0295 to 0300). Processed data has had outliers removed. Processed line data are available in *.gsf and ascii format, and processed bathymetry and backscatter grids in geotiff format. Additional information regarding this dataset, including further information on processing streams, is contained in the GSM data acquisition and processing report. Additional data products may be available on request.

This record describes gravity data collected on RV Investigator voyage IN2019_V07, 'RAN Hydrographic and Maritime Heritage Surveys' which departed Hobart on the 11 April 2019 and returned to Hobart on the 23 April 2019. The gravity meter instrument is a MicroG Lacoste Air-Sea II. Data are stored in .ENV and .DAT data files at CSIRO. There are 13 files totalling 197 MB of raw data in this dataset. Wharf tie[s] were not undertaken. but static readings were obtained at the Start and End of the voyage alongside in Hobart. No processing has been conducted on this data. Additional information regarding this dataset is contained in the GSM data acquisition and processing report.

This record describes multibeam echosounder data collected on RV Investigator voyage IN2019_V07, 'RAN Hydrographic and Maritime Heritage Surveys' which departed Hobart on the 11 April 2019 and returned to Hobart on the 23 April 2019. The Kongsberg EM122 multibeam echosounder was used to acquire seafloor bathymetry, backscatter information [and watercolumn backscatter] along the Tasmanian East Coast/Tasman Sea. The EM122 provides a 1 degree by 1 degree angular resolution. The echosounder's nominal frequency is 12 kHz. Data are stored in *.all raw format for bathymetry and backscatter and *.wcd format for watercolumn backscatter at CSIRO. There are 102 files totalling 3.37 GB of raw data in this dataset. Sound velocity profiles were applied to this data during data acquisition. Bathymetry data contained in *.all format are corrected for motion and position. Tide corrections were not applied to the processed data. Processed data had outliers removed. Processed line data are available in *.gsf and ascii format, and processed bathymetry and backscatter grids in geotiff format. Additional information regarding this dataset, including information on processing streams, is contained in the GSM data acquisition and processing report. Additional data products may be available on request.

This record describes the Acoustic Doppler Current Profiler (ADCP) data collected from the Marine National Facility RV Investigator voyage IN2019_V07, titled: "RAN Hydrographic and Maritime Heritage Surveys." The voyage took place from Hobart (TAS) to Hobart between April 11 and April 23, 2019. Data was collected during IN2019_V07 for parts of the voyage; however, gaps in the data occur at times when multibeam surveys were conducted. Data was collected using UHDAS and post-processed using CODAS. Both the RDI Ocean Surveyor 150kHz ADCP and the RDI Ocean Surveyor 75kHz ADCP were run in narrowband. Internal triggering was used. The drop keel was at 2m below the waterline for most of the voyage. See the voyage computing and electronics report for more details regarding data acquisition. This dataset was processed and then archived within the CSIRO Oceans and Atmosphere (O&A) Information and Data Centre (IDC) in Hobart.

This record describes Hydrology (HYD) data collected from the Marine National Facility (MNF) RV Investigator voyage IN2019_V07, titled:titled "RAN Hydrographic and Maritime Heritage Surveys. " The voyage took place from Hobart (TAS) to Hobart between April 11 and April 23, 2019. Hydrology samples were collected from Niskin bottles sampled at various depths during Conductivity-Temperature-Depth (CTD) deployments. Parameters analysed were salinity, dissolved oxygen, phosphate, silicate, nitrate plus nitrite and ammonium. This dataset has been archived at the CSIRO O&A Information and Data Centre (IDC) in Hobart. Additional information regarding this dataset is contained in the Voyage Report and Data Processing Report.

This record describes the Conductivity-Temperature-Depth (CTD) data collected from the Marine National Facility RV Investigator voyage IN2019_V07, titled "RAN Hydrographic and Maritime Heritage Surveys." The voyage took place from Hobart (TAS) to Hobart between April 11 and April 23, 2019. Data for 10 deployments were acquired using the Sea-Bird SBE911 CTD 23, fitted with 36 twelve litre bottles on the rosette sampler. Sea-Bird-supplied calibration factors were used to compute the pressures and preliminary conductivity values. CSIRO-supplied calibrations were applied to the temperature data. The data were subjected to automated QC to remove spikes and out-of-range values. Casts 1, 2, and 3 were test casts to verify the recently serviced secondary altimeter data and no bottles were fired during those deployments. A Wetlabs CSTAR Transmissometer, Wetlabs CDOM Fluorometer, and PAR sensor were also installed on the auxiliary A/D channels of the CTD. The collected data were subsequently processed and archived within the CSIRO Oceans and Atmosphere (O&A) Information and Data Centre (IDC) in Hobart. Additional information regarding this dataset may be contained in the Voyage Summary and the CTD Data Processing Report.

This record describes the Underway (UWY) data collected from the Marine National Facility (MNF) RV Investigator Voyage IN2019_V07, titled: "RAN Hydrographic and Maritime Heritage Surveys." The voyage took place between April 11 and April 23, 2019 departing from Hobart (TAS) and arriving in Hobart. Standard Underway data is continuously recorded, consisting of: (1) Navigation data (NAV): Latitude, Longitude, Speed, Heading, Course Over Ground, Gyros, and Doppler Log (dual GPS instrument). (2) Thermosalinograph (TSG): Water Salinity, Flow-Rate, Temperature, Fluorescence, pCO2 and Optode/Oxygen. (3) Atmospheric (MET): Humidity, Wind Speed and Direction (vane and ultrasonic), Radiometer/Sea Surface Temperature, Pyranometer/Solar Radiation, Photosynthetically Active Radiation (PAR), Air Temperature, Air Pressure, Rain, Ozone and Trace Gases (port and starboard instruments). The quality-controlled RV Investigator underway meteorological and SST data are supplied to the IMOS AODN where they are publicly available at the "Ships of Opportunity" Thredds server (http://thredds.aodn.org.au/thredds/catalog/IMOS/SOOP/SOOP-ASF/VLMJ_Investigator/catalog.html) for research. From there, they are downloaded by NOAA for their In Situ Quality Monitoring web site (iQUAM2) and made available for satellite SST validation. The SBE 38 SST data are used within the Australian Bureau of Meteorology for real-time satellite SST validation and ingested into real-time SST analyses which are then used as the boundary condition for Numerical Weather Prediction models. The meteorological and SST data are uploaded onto the Global Telecommunications System (GTS) for global dissemination to Meteorological Agencies, and separately supplied to the SAMOS (http://samos.coaps.fsu.edu/html/) Project for air-sea flux research. The real-time SBE 38 SST data are currently (2017) used in the following data products (accessed via the GTS): • International Comprehensive Ocean-Atmosphere Data Set (ICOADS R3.0) (http://icoads.noaa.gov/) • NOAA NCEI Extended Reconstructed Sea Surface Temperature version 4 (ERSST.v4) (https://www.ncdc.noaa.gov/data-access/marineocean-data/extended-reconstructed-sea-surface-temperature-ersst-v4) • Hadley Centre SST Data Set (HadSST3) (http://www.metoffice.gov.uk/hadobs/hadsst3/) • Global Ocean Surface Underway Data (GOSUD) Project (http://www.gosud.org/) • Bureau of Meteorology daily and weekly SST analyses (http://www.bom.gov.au/marine/sst.shtml) • NOAA NCEI “Reynolds” daily global OISST analysis (https://www.ncdc.noaa.gov/oisst) • NASA JPL “MUR” 1 km daily global SST analysis (https://mur.jpl.nasa.gov/) • UK Met Office “OSTIA” daily global SST analysis (http://ghrsst-pp.metoffice.com/pages/latest_analysis/ostia.html) • CMC daily global SST analysis • Ourocean “G1SST” global daily 1 km SST analysis (https://ourocean.jpl.nasa.gov/SST) As part of the underway data gathering system, other datasets are produced (e.g., pCO2, ISAR SST) which are processed separately and have their own metadata records. Data are recorded at 5 second intervals. Near real-time data are available via the link "Visualisation tool for Underway Data." This dataset will be processed and archived within the CSIRO Oceans & Atmosphere (O&A) Information and Data Centre (IDC) in Hobart (TAS). Data are available at time intervals of 5 sec (NetCDF format), 10 sec and 5 min (ASCII format). Additional information regarding this dataset is contained in the Voyage Summary and/or the Data Processing Report for this voyage.

This record describes the End of Voyage (EOV) archive from the Marine National Facility (MNF) RV Investigator research voyage IN2019_V07, titled "RAN Hydrographic and Maritime Heritage Surveys." The voyage took place from Hobart (TAS) to Hobart between April 11 and April 23, 2019 (AEST). For further information refer to the Voyage documentation links below. Instruments used and data collected include: Regular measurements: Acoustic Doppler Current Profiler (ADCP; 75, 150 KHz ), Fisheries echosounder (EK60), Multibeam Echosounder (EM710, EM122), Sub-bottom Profiler (SBP120), Gravimeter, GPS Positioning System, Doppler Velocity Log, Temperature, Humidity, Pressure, Wind and Rain sensors, Photosynthetically Active Radiation (PAR) sensor, Precision Infrared Radiometer (PIR), Precision Spectral Pyranometer (PSP), Nephelometer, pCO2, Condensation Particle Counters (CPC), Cloud Condensation Nuclei counter (CCN), Scanning Mobility Particle Sizers (SMPS), Multiangle Absorption Photometer (MAAP), Starboard and Portside Radiometers, Radon, Ozone and Oxygen sensors, Weather Radar, Greenhouse Gas Analysers (Picarro), Infrared Sea Surface Temperature Autonomous Radiometer (ISAR), Fluorometer, Oxygen optode, Thermosalinographs (TSG), CTD, Hydrochemistry. Voyage-specific measurements: Bird Observations, Triaxus, ECO Triplet, Ultra Short BaseLine Underwater Positioning System (USBL), Brenke Sled, Sediment Grab, Multi-corer, Video. The archive for the IN2019_V07 EOV raw data is curated by the CSIRO National Collections and Marine Infrastructure (NCMI) Information and Data Centre (IDC) in Hobart, with a permanent archive at the CSIRO Data Access Portal (DAP, https://data.csiro.au/dap/), providing access to participants and processors of the data collected in the voyage. All voyage documentation is available electronically to MNF support via the local network. Access to voyage documentation for non-CSIRO participants can be made via NCMI_DataLibrarians@csiro.au.